Hardware Insert
Sends audio out of an output on your audio device to outboard gear and brings the return back in, with level, invert and dry/wet controls.

Hardware Insert routes a track out through a physical output of your audio interface and back in through an input, so you can use outboard gear as an effect. It can also sit in a Patcher. Its round trip is measured and the project delay compensation is built on it.
Controls
| Control | What it does |
|---|---|
| Output | Audio device output that receives the send. |
| Mono (L+R to one output) | Sends the sum of both channels to a single output. |
| Send | Level sent to the device. |
| Input | Audio device input for the return. |
| Stereo pair | Uses two inputs as a stereo return. |
| Return | Level of the returned signal. |
| Invert | Inverts the polarity of the return. |
| Ping | Measures the round trip through the device. |
| Delay (samples) | Round trip delay in samples. |
| Dry/wet | Balance of dry and returned signal. |
Tips
- With no device open, the round trip shows a note and the plugin has nothing to send to.
- Run Ping with your gear connected to set the delay.