LYNX SHARE
All wiki pages

Pocket Phaser

Six-stage phaser with feedback, a centre frequency, a tempo-synced or free LFO with three shapes, and a stereo phase offset. Rebuilt from FL Studio Mobile's Phaser.

EffectModulation
Pocket Phaser

Pocket Phaser runs the sound through six first-order all-pass stages that an LFO sweeps, and adds the result on top of the dry signal. It is the engine that FL Studio Mobile projects (.flm) load their Phaser module on, with every value copied as it is, and it can also be added to any mixer slot.

Controls

ControlWhat it does
LFO rateLength of the LFO cycle when Sync is on, in 13 steps: 1/4, 3/8, 1/2, 3/4, 1/1, 2/1, 4/1, 8/1, 1 bar, 2 bars, 4 bars, 8 bars, 16 bars.
LFO amountHow far the LFO moves the stages, 0 to 100 % on a cubic law.
FeedbackFeeds the last stage back into the first, 0 to 100 % (up to 0.95).
FrequencyCentre of the sweep, 50 Hz to 16 kHz on a square law.
MixLevel of the phased signal added to the dry signal, 0 to 100 % on a square law. The dry signal stays at full level.
SyncOn uses LFO rate and follows the song position. Off uses LFO speed.
LFO speedSpeed of the LFO when Sync is off, 0.1 Hz to 10 Hz on a cubic law.
LFO shapeSine, Saw or Square.
StereoMoves the right channel's LFO ahead in phase, up to half a cycle at 100 %.

Tips

  • The rate labels are FL Studio Mobile's own: 1/1 is one beat and 1 bar is sixteen beats, so 16 bars is 256 beats.
  • The sweep is limited to the range 50 Hz to 16 kHz.