LYNX SHARE
All wiki pages

Maximus

Three-band compressor, limiter and saturator for mastering, with a master section, adjustable crossovers and a low cut.

EffectDynamicsOpens FL's Maximus settings from .flp
Maximus

Maximus splits the signal into low, mid and high bands and processes each with its own dynamics, plus a master stage. It is meant for the end of a mixer chain. The docs mark it with a dagger, which means it reads data from your own FL Studio installation, and some imported states, such as the linear-phase split and Master Mid mode, are only approximated.

Controls

ControlWhat it does
Band tabsLow, Mid, High and Master, each with its own settings.
On, Comp off, Muted, OffThe state of the selected band.
Pre and Post gainLevel before and after the processing.
Thres and CeilThreshold and ceiling of the selected stage.
Att, Rel and SustainEnvelope times of the compressor.
Peak or RMSLevel detection mode.
Rel 2Second release time.
LMH del and LMH mixDelay and mix between the low, mid and high bands.
Low and High freqCrossover frequencies, each with 12 dB or 24 dB slopes.
Low cutHigh-pass filter at the input.

Tips

  • Use the display to see which band is working while you set each tab.
  • Four of the 100 FL Studio demo states used the linear-phase split or Master Mid mode, which LYNX SHARE only approximates.