Pocket Spacer
Stereo tool with a left/right delay, pan, separation, a mid/side delay, polarity switches for each pair and three stereo modes. Rebuilt from FL Studio Mobile's Spacer.

Pocket Spacer moves a sound around the stereo field with short delays, polarity inversion and a width control. Use it to offset one side, narrow or widen a track, or work on mid and side separately. It is the engine that FL Studio Mobile projects (.flm) load their Spacer module on, with every value copied as it is, and it can also be added to any mixer slot.
Controls
| Control | What it does |
|---|---|
| L/R delay | Delays one side by up to 300 ms on a cubic law. Right of centre delays the left channel, left of centre delays the right channel. Reads off in the centre. |
| Pan | Lowers the level of the opposite side. Reads Center in the middle, then 0 to 100 %. |
| Separation | Bipolar, -100 % to +100 %, off in the centre. Positive values narrow the image down to mono. Negative values subtract part of each channel from the other to widen it. |
| L/R inversion | Inverts the polarity of the channels: none, left, right or both. |
| M/S delay | Delays one signal of the mid/side pair by up to 100 ms on a fifth-power law, so the range near the centre is very fine (microseconds). Right of centre delays mid, left of centre delays side. |
| M/S inversion | Inverts the polarity of the mid/side pair: none, mid, side or both. |
| Stereo mode | Standard encodes to mid/side, applies the M/S stage and decodes back to left/right. Output M/S leaves the result as mid on the left and side on the right. Input M/S treats the incoming left and right as mid and side and decodes them to left/right. |
Tips
- The four continuous controls glide to a new value, so a delay change bends the pitch for a moment.
- The delays are part of the sound and are not reported as latency.