LYNX SHARE
All wiki pages

Hardware Insert

Sends audio out of an output on your audio device to outboard gear and brings the return back in, with level, invert and dry/wet controls.

ToolRouting
Hardware Insert

Hardware Insert routes a track out through a physical output of your audio interface and back in through an input, so you can use outboard gear as an effect. It can also sit in a Patcher. Its round trip is measured and the project delay compensation is built on it.

Controls

ControlWhat it does
OutputAudio device output that receives the send.
Mono (L+R to one output)Sends the sum of both channels to a single output.
SendLevel sent to the device.
InputAudio device input for the return.
Stereo pairUses two inputs as a stereo return.
ReturnLevel of the returned signal.
InvertInverts the polarity of the return.
PingMeasures the round trip through the device.
Delay (samples)Round trip delay in samples.
Dry/wetBalance of dry and returned signal.

Tips

  • With no device open, the round trip shows a note and the plugin has nothing to send to.
  • Run Ping with your gear connected to set the delay.