Multiband Delay
Splits the sound into 16 bands, each with its own delay, volume and pan, with eight switchable banks and a morph control.

Multiband Delay splits the signal into 16 bands, sends each band through its own delay line with feedback, volume and pan, and sums the bands again. Eight banks each hold a delay time, a volume and a pan per band. It loads the settings of the FL Studio Multiband Delay from an imported .flp project.
Controls
| Control | What it does |
|---|---|
| Band display | Sixteen bars with their frequencies. Drag across them to draw the value of each band for the chosen target and bank. |
| Delay / Vol / Pan | Selects which of the three values per band the bars show and edit. |
| Bank 1 to 8 | Selects the bank the bars show and edit. |
| Gentle / Steep / Linear phase | Type of the band crossover. Linear phase adds 1536 samples of latency, which is reported for delay compensation. |
| Scale | Scales the delay times of all bands. The knob is bipolar. |
| x 0.1 | Shortens the delay times to a tenth. |
| H | Harmonic scale. The delay times follow a pitch scale, and Scale moves it in semitone steps. |
| W | Weighting. Derives each band's feedback from a decay time set by Feedback, so short and long delays die away over the same time. |
| Feedback | Amount of each band's delayed signal fed back into its delay line, up to 95 percent. |
| Smoothing time | How slowly the delay times glide to new values. |
| Keep pitch | Crossfades to a new delay time over 100 ms instead of gliding, so the pitch does not bend. |
| Morph | Interpolates the band values between neighbouring banks, from bank 1 at the left to bank 8 at the right. |
| Wet: Comp / Sat / Clip | Stage on the summed bands: a compressor, a saturator or a hard clip. |
| HP | High-pass filter on the summed bands, 10 Hz to 1 kHz. |
| Mix | Balance between the dry signal and the delayed bands. The dry signal is delayed to match the plugin's latency. |
Tips
- Automate Morph to move through the eight banks.
- The selected target and bank are saved with the plugin state.